How do I configure a seat belt sensor?

In the AVLView application, you may view the status of Ignition, A/C, Seatbelt, door etc.

To enable the parameters, you may install GPS devices with digital inputs which should be tapped with  respective accessory wiring.

To view the status, you may map the GPS device digital inputs to corresponding accessories in the platform.

Please follow below steps:

Step 1: Identify the corresponding device digital input connected with seat belt wiring

(To view the device data, please click on view device data tab available in partner portal)

NMVKkjVleu3EBO3KaUWQX jCrxwSgCEZiDiFvtYRCXvPkIWAeorP7Eqc9nX2KBQj9L ncP79WTRAVMB0 JMOlkmphteOkB3XtYoT u6hoCNp7W2EDXr4yehEhBK1qN0ESgLeO 1P

Step 2: Check device digital inputs status(High state or low state) from device data report

r7iqf5 ISNfY1p8FYUyIYhkhooYb0kA1prpaNgQhB230lfA OqwWpU4xJ486wOZNWDwPYW6EvM fn6GqB1q6iva52dc JsFavQwYqdPsWIkqnme1uRjVM8tVW7Xtwb m 8RwvmGq

Step 3: Configure the corresponding digital input to “Seat belt worn” in IO mapping under device configuration tab.

SFkqrl3I9Zo6FRHiQcfKcH8DuC3vmrU3 6WeVYgrmA9L jPai0aay4BGUMDATjtS
Xa3rgYPB9Hcy24iIddGJWnHNaxoBiE8YlUgVTBFJOIq